so ye it now gonna have similarity with a suzuki carry minitruck for interior.. like the door panels and dash
because why not ..also original interior feels ugly somehow.

engine, suspension and general stuff is complete
still more to do

Quote from bayanofmansorofisky :

When size doesn't matter

compact, light weight and reliable.. all in one!

side note: some early modeling stage, plans to have 8 different configurations!
most likely stock engine specs or whatever fits well.

suggestions, opinions and thoughts are welcomed

h2r ninja swap

With the new animation system, is it possible to have the cardan shaft spin depending on engine RPM?
It is quite visible in that truck so might be a good experiment.

Quote from Gutholz :

With the new animation system, is it possible to have the cardan shaft spin depending on engine RPM?
It is quite visible in that truck so might be a good experiment.

Rotators depending on RPM are not supported yet.

This vehicle escaped my notice, it's so fun. The engine pulls surprisingly well. I think Fov should be taken back a little. Once the suspension is softened, the risk of rollover is minimized.

Quote from seksen :

This vehicle escaped my notice, it's so fun. The engine pulls surprisingly well...

Thanks, unfortunately theres so little space for driver position adjustments. However i was infact planning to modify the weight distribution so theres more weight on the rear. Rollover will be minimized, but i just didn't have the time yet

Quote from bayanofmansorofisky :

Thanks, unfortunately theres so little space for driver position adjustments. However i was infact planning to modify the weight distribution so theres more weight on the rear. Rollover will be minimized, but i just didn't have the time yet

I think the weight distribution is good because when the front is light, the vehicle deviates from the lane a lot.