I am trying to develop a layout for blackwood that shows You the driving line, where to brake, turn in points etc.
These are the cone codes that indicate what you should be doing:
(Throtle / Brake Indicators)
Green (standing) - Full throtle
Yellow (standing) - Breaking point aproaching
Red pointer - Breaking point
Red (standing) - Keep breaking
Green pointer - Slowly apply throtle
(Racing line Indicators)
While (standing) - Turn in point aproaching
Blue pointer - Turn in now
Blue (standing) - Apex
So far, I have only done the layout for the first sector and would like some feedback...
The question for beginners:
Does it help?
The question for faster drivers:
Do I have the racing line right? Is it as close to the right line as it should be? If I have made mistakes, pleae point them out.
Please use a good setup for this. I will upload the one I use, courtesy of Fabio M.G., but race_1 should work fine. The layout and Fabio M.G.'s setup are attached.
Note: DEMO RACERS WILL NOT BE ABLE TO USE THIS LAYOUT
These are the cone codes that indicate what you should be doing:
(Throtle / Brake Indicators)
Green (standing) - Full throtle
Yellow (standing) - Breaking point aproaching
Red pointer - Breaking point
Red (standing) - Keep breaking
Green pointer - Slowly apply throtle
(Racing line Indicators)
While (standing) - Turn in point aproaching
Blue pointer - Turn in now
Blue (standing) - Apex
So far, I have only done the layout for the first sector and would like some feedback...
The question for beginners:
Does it help?
The question for faster drivers:
Do I have the racing line right? Is it as close to the right line as it should be? If I have made mistakes, pleae point them out.
Please use a good setup for this. I will upload the one I use, courtesy of Fabio M.G., but race_1 should work fine. The layout and Fabio M.G.'s setup are attached.
Note: DEMO RACERS WILL NOT BE ABLE TO USE THIS LAYOUT