Hey everyone.
I was just curious as to how people are getting on with the LX's at Kyoto. This week we'll be disconnecting from K... erm, I mean racing at Kyoto, in cloudy morning conditions, with a low wind, and an LXCC layout of straw bales.
Have people been practicing? How are people doing?
Personally I've just done a race simulation (for a racing simulation race ), and am pretty happy with my setup (which I won't be posting just yet, so don't ask in case my answer offends), and my lines. All I'm lacking now is a margin for error on some of the more tricky, faster corners, but that's easily added.
My hotlap time, which is obviously in sunny, zero wind conditions without the bales, is currently at 2:49.95. However, this time is pretty meaningless for the LXCC with the layout - how are people coping with that? Again, personally, I'm finding them a little tricky in places. They seem to be just a little too close to the track for my liking, even if you're not 'cutting', so it'll take a bit of getting used to. My race simulation was conducted with them, and I found I clipped on ever-so-slightly every four or five laps. They also cost me time, as my lines and exit speeds have to be adjusted to avoid them. Are you coping okay?
I would also ask one of the stewards (Anton, James, Rob?) to clarify what will constitute a bale related incident?
If I clip one with my front inside wheel, but it doesn't move.
If I clip one with my rear inside wheel (perhaps after it hits my front), but it doesn't move appreciably.
If I clip one with a wheel, and it moves noticeably, but doesn't obstruct a following driver
If I clip one with a wheel, it moves, and requires avoidance by a following driver, or indeed causes an accident/contact with said following driver(s).
Which of the above will be considered for penalty?
Also, if you turn up to a corner, and the bales are missing from a previous incident, how strictly will the rule about not cutting where they used to be be applied? I ask because it's very difficult to judge where it was if it isn't there, and I fear that I may fall foul of this. In the interests of reducing the laptime impact of the bales I plan on being pretty close to them every lap, and it's inevitable that there will be the occasional little brush of them, or the extra cutting of the corner in their absence. I just want to know to what extent they will be stewarded, preferably before the event.
Maybe this thread can be the drivers briefing for the race? In which case I'm asking the first question
Edit: To clarify after Hyper's post below, it's not the use of the bales that I find a problem, nut just a few are a bit too close to the track. I know it's a hard compromise between giving drivers room and disallowing cutting, but some of the bales are either on or too close to the kerbs. One slight error and you'll hit them, even if you weren't intending to gain an advantage from cutting. This could be made worse in a racing environment where accuracy of lines is sometimes sacrificed to allow room or discourage a pass. Hence I would like a little clarification about what we (I?) can get away with or not.
I was just curious as to how people are getting on with the LX's at Kyoto. This week we'll be disconnecting from K... erm, I mean racing at Kyoto, in cloudy morning conditions, with a low wind, and an LXCC layout of straw bales.
Have people been practicing? How are people doing?
Personally I've just done a race simulation (for a racing simulation race ), and am pretty happy with my setup (which I won't be posting just yet, so don't ask in case my answer offends), and my lines. All I'm lacking now is a margin for error on some of the more tricky, faster corners, but that's easily added.
My hotlap time, which is obviously in sunny, zero wind conditions without the bales, is currently at 2:49.95. However, this time is pretty meaningless for the LXCC with the layout - how are people coping with that? Again, personally, I'm finding them a little tricky in places. They seem to be just a little too close to the track for my liking, even if you're not 'cutting', so it'll take a bit of getting used to. My race simulation was conducted with them, and I found I clipped on ever-so-slightly every four or five laps. They also cost me time, as my lines and exit speeds have to be adjusted to avoid them. Are you coping okay?
I would also ask one of the stewards (Anton, James, Rob?) to clarify what will constitute a bale related incident?
If I clip one with my front inside wheel, but it doesn't move.
If I clip one with my rear inside wheel (perhaps after it hits my front), but it doesn't move appreciably.
If I clip one with a wheel, and it moves noticeably, but doesn't obstruct a following driver
If I clip one with a wheel, it moves, and requires avoidance by a following driver, or indeed causes an accident/contact with said following driver(s).
Which of the above will be considered for penalty?
Also, if you turn up to a corner, and the bales are missing from a previous incident, how strictly will the rule about not cutting where they used to be be applied? I ask because it's very difficult to judge where it was if it isn't there, and I fear that I may fall foul of this. In the interests of reducing the laptime impact of the bales I plan on being pretty close to them every lap, and it's inevitable that there will be the occasional little brush of them, or the extra cutting of the corner in their absence. I just want to know to what extent they will be stewarded, preferably before the event.
Maybe this thread can be the drivers briefing for the race? In which case I'm asking the first question
Edit: To clarify after Hyper's post below, it's not the use of the bales that I find a problem, nut just a few are a bit too close to the track. I know it's a hard compromise between giving drivers room and disallowing cutting, but some of the bales are either on or too close to the kerbs. One slight error and you'll hit them, even if you weren't intending to gain an advantage from cutting. This could be made worse in a racing environment where accuracy of lines is sometimes sacrificed to allow room or discourage a pass. Hence I would like a little clarification about what we (I?) can get away with or not.