Is it possible to do a burnt out before a drag, Then pull forward to stage and wait for lights as in reality??
Thanks

Its possible, but you would get a fault start id say

ok didnt think it would be? I have seen on the demo servers that on the straight of BL GP track they have staging lights for dragging. Any ideas on how to introduce that to an autocross drag???

This might be the application to use. I dont know too much about it but it should be all there in text

Quote from niall09 :

Its possible, but you would get a fault start id say

depends from the car and a set, I'd say. I was curious about it some time ago, I used XRR at AS3 start and I managed to do burnout without getting a false start, allthough the time you have on the start for raising turbo pressure and the burnout itself is very limited. And I didn't really noticed any positive effect of what I've done either

I forget, how is a burnout done? (Manual transmission, no auto clutch).

Quote from agm_ultimatex :

I forget, how is a burnout done? (Manual transmission, no auto clutch).

Well it can be hard without auto Clutch cause you have too keep the car in Neutral while holding the gas to raise turbo pressure, then you need to hold brakes while still holding Gas, switch into 1st and drop the clutch. With auto clutch its just Gas+Brake

Not all cars can do it without moving forward, XRR and XRT can do it with most of sets, not with drag sets though, because drag sets usually have very low rear tyres pressure and high fronts.