Hi,
I got a question about jetting my 2006 Honda 250EX.
First of all, I'd like to thank you for maing this thread, it really helped me making my quad faster (If you can call a 250EX 'fast' lol). I did the following steps:
1) Make sure your bike is clean prior. Turn Gas line to OFF
2) Pop the seat off
3) Remove tabs off left side plastic (left side when sitting on bike)
4) Remove tabs off airbox brackets
5) loosen clamps to snorkel and carb
6) remove crankcase breather tube (major PITA if you havent done it before)
7) Yank airbox out
But I'm stuck at:
8) remove 2 nuts holding carb to intake manifold
The two nuts are not really accessible easilly so I would like to know how you guys remove them? It would really help me as I can't do anything else right now because of those two nuts.
Also, I was planning to jet my quad this way:
Stock exhaust, no airbox lid, UNI/K&N filter: 102 main, same e-clip setting
But I'm not having those exact settings. Mine is like this:
Unbrided stock exhaust, no airbox lid + few holes in the airbox, UNI filter:
What main jet setting should I use as ince I can't adjust the e-clip setting?
Thanks in advance for your help!