Well, I put this into the Wheels and controllers subforum as I think this might be an issue with my wheel.

My problem is that when I shift in an LX4 using the paddles behind the wheel and setting sequential mode + auto clutch in the LFS driver options, it uses the clutch.
Speccing some other people, they seem to be able to do it without letting off the gas pedal or using the clutch.
I asked one of my friends who's doing it that way, to what he set it in the options and it turned out he has the exact same settings as I do: Sequential mode + auto clutch.

How is this possible? Also when he uses the auto shift mode, it shifts without using the clutch or letting off the gas pedal.
If i use auto shift mode, it uses the clutch and goes off the gas until the new gear is in.

As far as I know, LX4 has no sequential transmission. So what am I doing wrong? I dont even have my H-shifter plugged in ..


I hope you get what I mean. I might have to rephrase it though because it's a bit complicated to explain :P

The shift is likely so fast that their lifting and clutching isn't shown over the connection. i.e. it occurs between packets.

At bit like you can't judge braking points because they usually have started braking before you see their brake indicator jump up.

Quote from tristancliffe :

the shift is likely so fast that their lifting and clutching isn't shown over the connection. I.e. It occurs between packets.

At bit like you can't judge braking points because they usually have started braking before you see their brake indicator jump up.

+1