Hallo

I am having problems with my motion 2DOF (prosimu.com, 100 mm actuators based)

I use Lince (former E69) software to power my 2DOF, which works perfectly with iRacing and Assetto. But it does not work with LFS. I was told by prosimu.com to change CFG.TXT file in LFS folder with these settings:

Conn To Master 1
OutSim Mode 1
OutSim Delay 1
OutSim IP 127.0.0.1
OutSim Port 4123
OutSim ID 0
OutGauge Mode 1
OutGauge Delay 1
OutGauge IP 127.0.0.1
OutGauge Port 4124
OutGauge ID 0

I did it but still no movement.

Maybe some of you are able to help me please.

Tom

Finally I got Lince running, a bit jerky but running. The problem is that if I run Lince and SimCommander 4 for SimVibe the cfg.txt changes to its previous values. If I run Lince alone the 2DOF work.

Perfect situation is I can have both Lince and SC4 running well. Any suggestions are welcome

Hi mate, do you mean just with LFS? I use Lince and SimVibe but have tried them together on LFS.
I will have a look shortly, but you could do me a favour and share your Lince settings for me to have a look/try

Quote from museumsteve :

Hi mate, do you mean just with LFS? I use Lince and SimVibe but have tried them together on LFS.
I will have a look shortly, but you could do me a favour and share your Lince settings for me to have a look/try

Just with LFS - with AC and iR both SV and Lince work perfectly.

My Lince settings for LFS are simple - all is set to 50 apart from last two RPM and sth else.